Bondtech BMG extruder clone review

Before Hermera, long, long ago‚Ķ Before the E3D Hermera was released for sale, one of the best dual-drive extruders on the market was the Bondtech BMG. This is a beast of an extruder and is able to push out even the most stubborn of filaments without even breaking a sweat, but it’s expensive. very expensive….

How to use the BMI160 IMU

The Bosch BMI160 IMU is a cheap and easy way to add motion sensing to your Arduino, so today I’m going to show you how to use the BMI160 IMU in your next project! The nerdy stuff. The Bosch BMI160 is a 16-bit, tri-axial gyroscope, and accelerometer, basically meaning that it has a 3-axis gyro…

How to start a blog in 2020

I’ve thought about starting a blog for a while and I always wondered how to do it. Should I use Wix, Squarespace or WordPress? So in this post, I’m going to show you how to start a blog in 2020. Where to start. There are many different ways to start a blog both paid and…

Prusa clone Powder-coated PEI spring steel sheet review

It was while… It was while I was removing a particularly stubborn print from my glue-stick covered glass plate that I thought a better, less difficult, flatter and more consistent print surface was in order. So after fitting a new aluminium heated bed, I set out to find one and very quickly found the clone…